Wireless Access Point Registration Form	home  |   search  |   help
This form is used to register your wireless access point. Your wireless access point must be located in Boelter Hall, Engineering I, or Engineering IV. There is no charge for wireless access point registration, but a valid recharge ID is required to process this request. Wireless access points on all SEASnet maintained networks but not registered with SEASnet will be shut down.

Requestor Information:
Requestor E-mail	Must be in the form of ...ucla.edu
Recharge ID	(ex. KA00)
Device Information:
AP Manufacturer	(ex. Linksys)
AP Model	(ex. WAP54G)
Wireless Technology	A B G
AP and Antenna Location	Building and Room number
Signal Strength	(ex. 100% or 100 mWatts)
Signal Coverage/Distance (optional)	Approximate distance vertically and horizontally
Channel Used	1 6 11
Security Information:
Encryption Used	(ex. WEP, WPA)
Authentication Used	(ex. MAC filtering, Radius server)
Network Information:
Wireless/Air MAC Address
SSID	Note: SSID can not be broadcast
SEASnet IP Address of Ethernet Interface	If Network Address Translation (NAT) is enabled
DNS Name/Host Name	If NAT is enabled
SEASnet IP(s) used through AP	If NAT is disabled
Owner/User Information:
Primary User	Full name
Nearest Phone
Department
Faculty Advisor	Full name
Why is a private AP needed?
By submitting this form I am verifying that I have read and understood: UCLA standards on use of wireless on campus networks that it is my responsibility to make sure the AP and any traffic through it is secure and not compromised that any security breaches via my AP and results thereof are my responsibility that if a compromised system holds personal data (e.g., Social Security number or credit card number), I must follow the procedure in UCLA Policy 420 to avoid violating California State Law that wireless networking is not secure even with WEP and MAC address filtering

SEASnet Help Desk, help (at) seas.ucla.edu, 2684 Boelter Hall (310)206-6864